invisaWear® invisaWear®
invisaWear® invisaWear®
SUPPORT

Regulatory

FCC Compliance Statement

 

Contains FCC ID: QOQ11

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesirable operation.

Any changes or modifications not expressly approved by invisaWear Technologies LLC could void the user's authority to operate the equipment.

 

FCC RF Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter meets both portable and mobile limits as demonstrated in the RF Exposure Analysis and SAR test report. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.

 

ISED Canada Compliance Statement

Contains IC: 5123A-11

 

This radio transmitter (IC: 5123A-11) has been approved by Industry Canada to operate with the embedded chip antenna. Other antenna types are strictly prohibited for use with this device.
This device complies with Industry Canada's license-exempt RSS standards. Operation is subject to the following two conditions:
  1. This device may not cause interference; and
  2. This device must accept any interference, including interference that may cause undesired operation of the device

RF Exposure Statement

This product has been tested for worst case RF exposure. As demonstrated in the SAR test report, this product can be mounted in touch with human body without further SAR evaluation.

 

CE Compliance Statement

This product is in conformity with the essential requirements of the Radio Equipment Directive (RED) (2014/53/EU).

 

Battery: CR1220 Lithium Battery

Rating: 3 Vdc 

 

Copyright Disclaimer

© 2021 invisaWear Technologies Corporation, All Rights Reserved. The invisaWear logo and name are trademarks owned by invisaWear Technologies Corporation. All other logos and marks are the property of their respective owners.

 

All products contain model number INV1001A.

 

Warning:  Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential installation.  This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

 

          However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.